Mute Mutes the output at the 1/4" unbalanced out Ground Lift Disconnects pin-1 at the XLR input
Output Instrument-level (variable), unbalanced Input XLR, 4 dB balanced line-level, AES standard (pin-2 hot) Intermodulation Distortion 0.0025% 1 kHz/-10 dB inputĭeviation from Linear Phase 2º 100 Hz 0º 800 Hz Total Harmonic Distortion 0.05% 20 Hz, 0.006% 1 kHz Keeps your JCR Reamp looking great for yearsĬircuit Type Passive, transformer isolatedįrequency Response 20 Hz to 20 kHz (☐.2 dB) Keeps the JCR Reamp from moving around when placed on the guitar amp Isolates and converts the impedance to properly feed the guitar ampįull bottom surface neoprene pad provides electrical isolation and mechanical insulation
#Reamp studios full
Heavy-duty 14-gauge steel construction for added durability and extra shielding against electromagnetic fieldsĭouble-sided PCB and full ground plane to assure low noise and high durability for trouble-free performanceĬreates protective zone around connectors, switches, and potentiometers for added protection High-pass (low-cut) setting to clean up low end mudįlat setting to bypass the filters and go back to the original reamp circuitĭisconnects ground at the balanced inputs to eliminate hum and buzz caused by ground loopsįlips the electrical polarity of the output to compensate for amps or effects that invert the signal Low-pass (high-cut) setting to warm overly bright amps Three-position switch used to select between preset EQ filter Sets the reamping output level to your amp Used to control the signal going from the Reamp JCR to the guitar or bass amplifier Silences the 1/4" output from the Reamp JCR going to the guitar or bass amplifier Transformer isolated to eliminate hum and buzz caused by ground loops Improves productivity while expanding creative optionsĬonnects from the output of your recording system to the Reamp JCRĬonnects from your recording workstation and is suitable for both lo-Z and hi-Z sourcesĬonnects from the Reamp JCR to amps and effects Original reamp circuit designed by John CunibertiĮasy-to-use, plug-and-play passive design
Lets you re-record tracks through a guitar or bass amp An on-board mute function has also been added to let you shut off the signal going to the amps while making adjustments or moving mics around the studio.
It also features separate XLR and 1/4" TRS input connectors, variable output level, and a 3-position filter that lets you tame excessive highs, warm up the lows, or simply bypass if you want to revert to the original circuit. It features a 100% passive design with John's original custom-wound transformer and circuit that are made in the USA. This reamper features the original reamp circuit designed by John Cuniberti. Additionally, you can also reamp the track later as the production develops. Once the performance has been captured, you can reamp the track even in the absence of the guitarist by moving the mics around the room, trying various amplifiers, or introducing effects. The benefits are tremendous: instead of worrying about the sound of the track, you can focus your attention on getting the best musical performance. The Radial Engineering Reamp JCR is a passive reamper that allows you to take a prerecorded track and send it back to a guitar or bass amplifier and re-record it.
0 kommentar(er)
